Injection Moulding and Waterproof Encapsulation for LED Modules

Epoxy and silicone injection moulding encapsulates LED modules for IP65 signage. Colour-stable, uniform light, made in Jiangmen since 2008.

Injection-moulded GMH E-series LED channel letter modules with sealed epoxy bodies and 170 degree optics
Moulded LED modules, sealed for IP65 signage use.
Short answer

Injection moulding and encapsulation seal LED circuits inside a solid epoxy or silicone body, giving the module mechanical strength and a waterproof barrier without a separate housing. GMH moulds LED modules for 4–25 cm channel letters in IP65 and IP67 versions, with 170° beam optics and LED binning for consistent colour across a sign face.

When this process applies

This capability covers moulded LED modules for illuminated signage: injection-moulded epoxy modules and silicone-sealed waterproof units. It does not cover general-purpose plastic moulding for third parties or tooling design for non-LED products.

Technical specifications

Moulding materialEpoxy resin and silicone
Protection achievedIP65 and IP67
Modules forLightbox side heights 4–25 cm
OpticsUp to 170° beam angle
Colour controlLED binned by CCT and brightness
Quality systemISO 9001

Where it is the right choice

  • Outdoor channel letters needing waterproof modules
  • Sign faces where uniform, dot-free light matters
  • Modules exposed to rain, dust or wash-down
  • Long runs where colour consistency between units is critical

Where it is the wrong choice

Stating this explicitly matters more than a capability list: if your part falls into one of these categories, another process will cost you less.

  • Low-volume one-off prototypes, where mould tooling is not justified
  • Products needing a transparent or lens-shaped optical housing
  • High-power modules generating heat that a solid encapsulation cannot dissipate

Equipment

  • Injection moulding presses for LED module encapsulation
  • Mould tooling for channel letter module families
  • Powered ageing racks for finished modules
  • Water-resistance test setup for IP65/IP67 validation
Injection Moulding & Encapsulation

Process questions

Why encapsulate LED modules instead of using a bare PCB?

Encapsulation gives a waterproof seal and physical strength in one step, so the module can sit inside a channel letter without a separate enclosure. For outdoor signs this is the practical route to an IP65 or IP67 rating.

Does moulding affect the colour of the light?

The encapsulant is chosen to keep colour stable, and LEDs are binned by colour temperature and brightness before assembly. Consistent binning is what stops a long sign face from showing banding between modules.

Can you mould a custom module shape?

Custom shapes require new tooling and are quoted case by case. For most channel letter applications a standard module from the 4–25 cm range is more economical and available sooner.

Tell us your sign project, get a product recommendation

Share your sign design — letter depth, face material, indoor or outdoor — and we will recommend the right LED modules, strip, power supply and protection rating, with a quotation. No obligation.

WhatsApp